This article concentrates on the enhanced Routing Information Protocol, also known as RIP version 2. I will show you the necessary configuration steps for RIPv2 so that you will be able to configure RIP on your own. Last time we covered, which included information on RIP operation, drawbacks, configuration, and much more.

Free Download Warriors Orochi PC Game Rip - In Warriors Orochi, the characters from both franchises must team up to wage war against this new yet powerful force. Get the latest music news, watch video clips from music shows, events, and exclusive performances from your favorite artists. Discover new music on MTV.

Today, we shift focus to RIPv2 and to illustrate the configuration steps I will use the same example I used in the first article, just for simplicity. I'll also give you a brief overview of the most important parts of both versions of RIP, which should be very useful for all of you out there studying for the and exams.

Routing Information Protocol Version 2 Both versions of RIP, RIPv1 and RIPv2, are Distance Vector Routing Protocols that use router hop counts as their metrics. They support a maximum hop count value of 15. Any router farther than 15 hops away is considered to be unreachable. Psihologia Crime Serial Online Subtitrat Gratis here.

The main enhancement of RIPv2 over its ancestor is the fact that it first sends the subnet mask with the updates; hence it is considered to be a classless routing protocol in the sense that it is able to distinguish among different subnets - which is something that is not found in RIPv1. Torrent Office Space Soundtrack Track. The following table presents in more details the main characteristics of RIPv2: Configuring RIPv2 As I mentioned before, I'll be using the same network diagram that I used in. Configuring RIP routing protocol consists of three basic steps: • Enabling RIP routing protocol on the router • Specifying the RIP version to run • Configuring the network addresses to be included in routing updates or specifying the interfaces to participate in routing updates Using the Cisco IOS, the command to enable RIP routing protocol is router rip. The version command is used to specify which RIP version to use (either 1 or 2).

If the version command is omitted then the router defaults to sending RIPv1 but can receive both RIPv1 and RIPv2. The network command is used to specify the directly connected subnets on the router to be configured and that are intended to be included in the routing updates. This is a good time to point out that you still specify classful networks with the network command. According to the classful, network specified, the subnets of that network are automatically identified and participate in the routing update. By default routing updates are summarized at network boundaries. In RIPv2 this auto summarization behavior can be turned off using the no auto-summary command.